Technical design as the Foundation of Reliable Automation

We provide design and engineering services in the field of industrial automation, focusing on power and technological equipment. Our work begins at the early stage of a project – during the creation of the technical proposal, refinement of specifications, and definition of functional and operational priorities.

We develop project documentation using the EPLAN platform, designing solutions that are technically consistent, manufacturable, and sustainable in the long term. These design outputs serve as a solid foundation for control cabinet manufacturing, control system implementation, and the subsequent operation of the technology.

 

Why Entrust Your Design to Us?

1.

Design Rooted in Operational Reality

We design solutions with regard to actual operation, maintenance, and future expandability. Our design is not created in isolation but is closely aligned with the technology and its intended usage.

2.

Unified Documentation in EPLAN

We process all design documentation on the EPLAN platform. This ensures a high level of standardization, output clarity, and seamless continuity with manufacturing and service.

3.

Close Collaboration with Manufacturing & Other Teams

Our design is developed in direct connection with control cabinet manufacturing and other departments. This allows us to eliminate clashes, ambiguities, and unnecessary modifications in later project stages.

4.

Clearly Defined Scope and Technical Priorities

We assist the customer right from the initial project phase – during proposal creation, scope refinement, and the setting of technical and schedule priorities.

CONTACT US

MCC Distribution Systems – Design of Power and Drive Circuits

We prepare design documentation for auxiliary power distribution systems and Motor Control Centers (MCC) for power generation and industrial facilities. The design is based on technological requirements, operational modes, and seamless coordination with cabinet manufacturing.

Single-line diagrams and power circuit schematics.

Drive control design (DOL, soft starters, frequency converters).

Feeder dimensioning and cabinet thermal calculations.

Device arrangement and cabinet layout design.

Control systems (TCS) – HW Architecture Design

We design the hardware architecture of Turbine Control Systems (TCS) for turbines and technological units in the power generation sector.

Design of system cabinets for DCS/PLC (power supply, protection, communication modules).

Development of I/O loop diagrams extending from the card down to the sensor.

Design of communication paths and control system network topology.

Preparation of signal lists and interconnection tables.

Generator Protection & Excitation – Design of Protection and Synchronization Circuits

We prepare design documentation for generator protection and excitation systems to ensure safe and stable power plant operation.

Connection of current (CT) and voltage (VT) instrument transformers for protection purposes.

Schematics for excitation systems and their interface with the block transformer.

Design of synchronization circuits and generator phasing logic.

Coordination with the generator manufacturer and incorporation of their requirements into the design.

Cabling and Cable Trays – Design of Technology wiring

We provide design services for both power and I&C (low-voltage) cabling, including the design of cable trays for power generation and industrial facilities. Our solutions are prepared with a strong emphasis on spatial coordination, safety, and installation feasibility.

Cable sizing and cable tray load capacity checks.

Coordination of cable routes with process technology and civil works.

Installation documentation, including cable schedules and length estimates.

CONTACT US